Here is a highly requested DIY that you all wanted to see. A colorful chain braided bracelet. With this technique you can even make a necklace. All you need are some pliers, tape, colorful cotton thread, some jumprings ,a clasp, scissors,chain.
Un tutorial extrem de cerut pe care vroiati sa vi-l arat. Cum facem o bratara din lant impletita cu ata colorata. Cu aceasta tehnica puteti face chiar si coliere. Aveti nevoie de un cleste , banda adeziva, ata colorata de goblen, zale, o carabina, o foarfeca si lant.
Measure the chain around your wrist and cut/ remove it to the lenght needed. Then measure the thread 3 times as long as the bracelet will be. Do that with all 6 threads.(you can pick as many colors as you want.)
Masoara ce lungime vrei lantul si taie la acea dimensiune. Ia ata si masoara de 3 ori lungimea bratarii, atat va avea un fir. Repeta procedeul pentru toate cele 6 fire( poti alege cate culori vrei).
Make a knot atone end
Fa un nod la capat.
Divide into two,cut the ends even and tape them a bit. It's easier to braid it this way.
Imparte firele in doua(cate 3), taie varfuril egal si pune putina banda adeziva. E mai usor de impletit asa.
.Put one thread through the first ring and behind the second thread.
Incepe prin a baga un capat prin prima za si in spatele celuilalt grup de ate.
Put the second one into the same ring from the back to the front. ( like braiding backwards.)
Al doilea grup va fi bagat din spate spre fata si pe sub celalalt grup.(ca si cand ai impleti invers)
Repeat these steps for each ring until you ge to the end.
Repeta acesti pasi pentru fiecare za in parte pana ce ajungi la capat.
Almost done.
Aproape gata.
Tie the thread at the end with a tight knot and cut the excess.
Leaga capatul atelor cu un nod strans si taie restul de ate ramas.
Mount the jumpring and clasp on one side. There you go!Simple as that!
Monteaza zala si carabina. Gata! atat de simplu.
Would you like more DIY projects?
Doriti mai multe astfel de tutoriale?
0 comments:
Post a Comment